Sanitizers

HT Spa Activator is an odorless shock that is the most favored product by hot tub owners whether they use chlorine or bromine. It is a powerful oxidizer formulated to be safe to use after each use of the hot tub whether you are using chlorine, bromine, or mineral purifiers. HT Spa Activator is a shock not a sanitizer and is extremely effective in eliminating organic contaminants introduced by bathers such as body oils, lotions, urine, etc. along with environmental factors like rain and wind. Essentially it allows sanitizers to more be effective in eliminating bacteria and viruses along with reducing the frequency of adding sanitizers in order to keep a proper ppm level. Best of all it contains no chlorine, unlike bromine, so it is essentially odorless. RECOMMENDED USE Add 2 ounces per 300 gallons of water each time you exit your spa or 2 ounces weekly if the spa has not been used. Make certain filtration pump is active for at least 30 minutes each time you add Spa Activator.

Read more less

HT Mineral Stick contains a mineral formula that destroys bacteria while neutralizing acids, which helps keep the pH in an acceptable range with less monitoring and assists in keeping your water crystal clear. Using the HT Mineral Stick helps reduce required levels of bromine or chlorine, improves spa pleasure by reducing the problems associated with bromine or chlorine, including faded bathing suits, premature damage to spa equipment or surfaces and smelly odors. Works on spas up to 600 gallons and requires replacement every 4 months, depending upon usage. RECOMMENDED USE Simply place in the spas skimmer basket and replace every 4 months. Should be used with bromine or chlorine and follow all directions for proper use of balancing and maintaining water quality.

Read more less

HT Chemicals uses the highest concentrate available on the market: 99% Sodium Dichloro and 55.5% Available Chlorine. Unlike many competitors our chemicals are produced and packaged in the USA, guaranteed to be fresh. Our Chlorine contains no scale forming minerals, dissolves instantly and is specifically formulated for warm water use in hot tubs! RECOMMENDED USE With pump on, add 1 teaspoon per 200 gallons of water on initial treatment. Repeat every 15 minutes if necessary to reach a 3 to 5 ppm of available chlorine. Use test strips to maintain 3 to 5 ppm reading. After each usage of spa it is recommended to add 2 ounces of HT Spa Activator (per 300 gallons of water) to shock and treat the water. Spa Activator does not raise yourMaintain 3 to 5 ppm of chorine and add HT Spa Activator weekly even when spa is not in use.

Read more less

The powerful oxygen-based oxidizer provides 2 benefits when used in conjunction with spa water sanitized by Chlorine. It helps eliminate contaminates introduced by bathers along with environmental factors like wind and rain. It also helps restore sparkle and clarity to the water without affecting hardness or stabiliser levels.Recommend using 1 ounce per every 100 gallons (3oz in a 300-gallon spa)

Read more less

Traditional Bromine Tablets are dissolving products that have a high percentage of chlorine and continue to emit a high scent. HT are non-dissolving, erosion based tablets that are extra hard and designed to work with HT Brom Bank a liquid bromide salt solution and HT Activator. Our products are simple to use, dramatically reduce the odor of chlorine in warm water hot tubs, and provide an improved sanitizing solution. Optimum range of active bromine residual is 2 to 5 ppm. RECOMMENDED USE On your initial fill add 1 ounce of HT Brom Bank per each 100 gallons of water to your spa. Install 3 Bromine Tablets per 300 gallons of spa water via the use of a Bromine Floating Dispenser. Adjust feeder to maintain a minimum of 2 ppm of active bromine residual. Maintain spa by adding no more than 3 tablets each time approximately every 5 to 7 days or as needed to maintain between 2 to 5 ppm. For additional sanitizing and to keep chlorine scent to a minimum add 2 ounce of HT Spa Activator after each use. HT Bromine Tablets can be used similar to traditional Tablets but not with the same effectiveness or benefits as prescribed within.

Read more less

HT Brom for Spas is a clear solution of Bromide Salts which remain in your spa water to activate and enhance the performance of our HT Bromine Tablets. Properly used with HT Bromide Tabs it immediately create pure bromine dramatically reducing the scent of chlorine found in all traditional bromine tablets. RECOMMENDED USE Add 2 ounces of Brom Bank to your spa on the initial fill before adding Bromine Tablets. Then after each use add 2 ounces of HT Spa Activator. For enhanced sanitation of your spa water simply add 2 ounces of Brom Bank every 1 to 2 weeks depending upon use.

Read more less

HT Spa Activator is an odorless shock that is the most favored product by hot tub owners whether they use chlorine or bromine. It is a powerful oxidizer formulated to be safe to use after each use of the hot tub whether you are using chlorine, bromine, or mineral purifiers. HT Spa Activator is a shock not a sanitizer and is extremely effective in eliminating organic contaminants introduced by bathers such as body oils, lotions, urine, etc. along with environmental factors like rain and wind. Essentially it allows sanitizers to more be effective in eliminating bacteria and viruses along with reducing the frequency of adding sanitizers in order to keep a proper ppm level. Best of all it contains no chlorine, unlike bromine, so it is essentially odorless. RECOMMENDED USE Add 2 ounces per 300 gallons of water each time you exit your spa or 2 ounces weekly if the spa has not been used. Make certain filtration pump is active for at least 30 minutes each time you add Spa Activator.

Read more less

HT Chemicals uses the highest concentrate available on the market: 99% Sodium Dichloro and 55.5% Available Chlorine. Unlike many competitors our chemicals are produced and packaged in the USA, guaranteed to be fresh. Our Chlorine contains no scale forming minerals, dissolves instantly and is specifically formulated for warm water use in hot tubs! RECOMMENDED USE With pump on, add 1 teaspoon per 200 gallons of water on initial treatment. Repeat every 15 minutes if necessary to reach a 3 to 5 ppm of available chlorine. Use test strips to maintain 3 to 5 ppm reading. After each usage of spa it is recommended to add 2 ounces of HT Spa Activator (per 300 gallons of water) to shock and treat the water. Spa Activator does not raise yourMaintain 3 to 5 ppm of chorine and add HT Spa Activator weekly even when spa is not in use.

Read more less